Allied Telesis VERSION 5.4.3-2.6 manual Bgp client-to-client reflection BGP and BGP4+

BGP and BGP4+ Commands

bgp client-to-client reflection (BGP and BGP4+)

This command restores route reflection from a BGP route reflector to clients, and is used to configure routers as route reflectors. Route reflectors are used when all Interior Border Gateway Protocol (iBGP) speakers are not fully meshed.

If the clients are fully meshed the route reflector is not required, use the no variant of this command to disable the client-to-client route reflection.

When a router is configured as a route reflector, client-to-client reflection is enabled by default.

The no variant of this command turns off client-to-client reflection.

Syntax bgp client-to-client reflection

no bgp client-to-client reflection

Default This command is enabled by default.

Mode Router Configuration

Example

awplus# configure terminal

awplus(config)# router bgp 100

awplus(config-router)#no bgp client-to-client reflection

Related Commands bgp cluster-id (BGP and BGP4+) neighbor route-reflector-client (BGP) show bgp ipv6 (BGP4+)

show ip bgp (BGP)

	Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D	AlliedWare PlusTM Operating System - Software Version 5.4.3-2.6	3.19