Allied Telesis VERSION 5.4.3-2.6, BGP4 manual Neighbor route-server-client BGP

BGP and BGP4+ Commands

awplus# configure terminal

awplus(config)# router bgp 10

awplus(config-router)# no neighbor 10.10.0.72 route-reflector-client

neighbor route-server-client (BGP)

Use this command to specify the peer as route server client.

Use the no variant of this command to disable this function.

Syntax neighbor <neighborid> route-server-client

no neighbor <neighborid> route-server-client

Parameter Description

<neighborid> {<ip-address><peer-group>}

<ip-address>The address of an IPv4 BGP neighbor, in dotted decimal notation A.B.C.D.

<peer-group>Enter the name of an existing peer-group. For information on how to create peer groups, refer to the neighbor peer-group (add a neighbor) (BGP and BGP+) command on page 3.144, and neighbor route-map (BGP and BGP4+) command on page 3.159. When this parameter is used with this command, the command applies on all peers in the specified group.

Mode Router Configuration

Examples

awplus# configure terminal

awplus(config)# router bgp 10

awplus(config-router)#neighbor 10.10.0.72 route-server-client

awplus# configure terminal awplus(config)# router bgp 10

awplus(config-router)# no neighbor 10.10.0.72 route-server-client

	Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D	AlliedWare PlusTM Operating System - Software Version 5.4.3-2.6	3.165