Allied Telesis Neighbor description BGP and BGP4+, Neighborid ip-addressipv6-addrpeer-group

BGP and BGP4+ Commands

neighbor description (BGP and BGP4+)

Use this command to associate a description with a BGP or a BGP4+ neighbor. We recommend adding descriptions to defined neighbors, so any network administrators or network engineers can see a description of connected BGP or BGP4+ peers on the switch.

Use the no variant of this command to remove the description from a BGP or a BGP4+ neighbor.

Syntax neighbor <neighborid> description <description>

no neighbor <neighborid> description [<description>]

Parameter Description

<neighborid> {<ip-address><ipv6-addr><peer-group>}

<ip-address>	Specify the address of an IPv4 BGP neighbor, in
	dotted decimal notation A.B.C.D.
<ipv6-addr>	Specify the address of an IPv6 BGP4+
	neighbor, entered in hexadecimal in the
	format X:X::X:X.

<peer-group>Enter the name of an existing peer-group. For information on how to create peer groups, refer to the neighbor peer-group (add a neighbor) (BGP and BGP+) command on page 3.144, and neighbor route-map (BGP and BGP4+) command on page 3.159. When this parameter is used with this command, the command applies on all peers in the specified group.

<description> Enter up to 80 characters of text describing the neighbor.

Mode [BGP] Router Configuration or IPv4 Address Family Configuration for a VRF instance

Mode [BGP4+] Router Configuration

Examples [BGP]

awplus# configure terminal

awplus(config)# router bgp 10

awplus(config-router)#neighbor 10.10.10.1 description Backup

router for sales

awplus# configure terminal awplus(config)# router bgp 10

awplus(config-router)#no neighbor 10.10.10.1 description

	Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.110	AlliedWare PlusTM Operating System - Software Version 5.4.3-2.6	C613-50032-01 REV D