Allied Telesis VERSION 5.4.3-2.6 manual Neighbor capability route-refresh BGP and BGP4+

BGP and BGP4+ Commands

neighbor capability route-refresh (BGP and BGP4+)

Use this command to advertise route-refresh capability to the specified BGP and BGP4+ neighbors.

Use the no variant of this command to disable this function

Syntax [BGP/BGP4+] neighbor <neighborid> capability route-refresh

no neighbor <neighborid> capability route-refresh

Parameter Description

<neighborid> {<ip-address>ipv6-addr><peer-group>}

		<ip-address>	Specify the address of an IPv4 BGP neighbor, in
			dotted decimal notation A.B.C.D.
		<ipv6-addr>	Specify the address of an IPv6 BGP4+ neighbor,
			entered in hexadecimal in the format X:X::X:X.
		<peer-group>	Enter the name of an existing peer-group. For
			information on how to create peer groups, refer
			to the neighbor peer-group (add a neighbor)
			(BGP and BGP+) command on page 3.144, and
			neighbor route-map (BGP and BGP4+)
			command on page 3.159. When this parameter
			is used with this command, the command
			applies on all peers in the specified group.
Mode [BGP/BGP4+]	Router Configuration
Default [BGP/BGP4+]	Enabled

Usage [BGP/BGP4+] Use this command to advertise to peer about route refresh capability support. If route refresh capability is supported, then router can dynamically request that the peer readvertises its Adj-RIB-Out.

	Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.102	AlliedWare PlusTM Operating System - Software Version 5.4.3-2.6	C613-50032-01 REV D