Allied Telesis VERSION 5.4.3-2.6 manual Neighbor override-capability BGP and BGP4+

BGP and BGP4+ Commands

neighbor override-capability (BGP and BGP4+)

Use this command to override a capability negotiation result for BGP and BGP4+.

Use the no variant of with this command to disable this function.

Syntax [BGP/BGP4+] neighbor <neighborid> override-capability

no neighbor <neighborid> override-capability

Parameter Description

<neighborid> {<ip-address><ipv6-addr><peer-group>}

<ip-address>Specify the address of an IPv4 BGP neighbor, in dotted decimal notation A.B.C.D.

<ipv6-addr>Specify the address of an IPv6 BGP4+ neighbor, entered in hexadecimal in the format X:X::X:X.

<peer-group>Enter the name of an existing peer-group. For information on how to create peer groups, refer to the neighbor peer-group (add a neighbor) (BGP and BGP+) command on page 3.144, and neighbor route-map (BGP and BGP4+) command on page 3.159. When this parameter is used with this command, the command applies on all peers in the specified group.

Mode [BGP/BGP4+] Router Configuration

Examples [BGP]

awplus# configure terminal

awplus(config)# router bgp 10

awplus(config-router)#neighbor 10.10.0.72 override-capability

awplus# configure terminal awplus(config)# router bgp 10

awplus(config-router)# no neighbor 10.10.0.72 override-capability

	Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D	AlliedWare PlusTM Operating System - Software Version 5.4.3-2.6	3.137