Allied Telesis VERSION 5.4.3-2.6 manual Neighbor maximum-prefix BGP and BGP4+, Threshold

BGP and BGP4+ Commands

awplus# configure terminal

awplus(config)# router bgp 10

awplus(config-router)#no neighbor group1 local-as 1

Related Commands neighbor peer-group (add a neighbor) (BGP and BGP+) neighbor route-map (BGP and BGP4+)

router bgp (BGP and BGP4+)

neighbor maximum-prefix (BGP and BGP4+)

Use this command to control the number of prefixes that can be received from a BGP or a BGP4+ neighbor.

Use the no variant of this command to disable this function. Do not specify threshold to apply the default threshold of 75% for the maximum number of prefixes before this is applied.

Syntax [BGP/BGP4+] neighbor <neighborid> maximum-prefix <maximum>

no neighbor <neighborid> maximum-prefix [<maximum>]

Parameter	Description
<neighborid>	{<ip-address><ipv6-addr><peer-group>}
	<ip-address>	Specify the address of an IPv4 BGP neighbor, in
		dotted decimal notation A.B.C.D.
	<ipv6-addr>	Specify the address of an IPv6 BGP4+ neighbor,
		entered in hexadecimal in the format X:X::X:X.
	<peer-group>	Name of an existing peer-group. For
		information on how to create peer groups, refer
		to the neighbor peer-group (add a neighbor)
		(BGP and BGP+) command on page 3.144, and
		neighbor route-map (BGP and BGP4+)
		command on page 3.159. When this parameter
		is used with this command, the command
		applies on all peers in the specified group.
<maximum>	<maxprefix> [<threshold>] [warning-only]
<maxprefix>	<1-4294967295>
	Specifies the maximum number of prefixes permitted.
<threshold>	<1-100>Specifies the threshold value, 1 to 100 percent. 75% by
	default.
warning-only	Only gives a warning message when the limit is exceeded.

Default [BGP/BGP4+] The default threshold value is 75%. If the threshold value is not specified this default is applied.

	Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D	AlliedWare PlusTM Operating System - Software Version 5.4.3-2.6	3.131