Allied Telesis BGP4, VERSION 5.4.3-2.6 manual AS number 200 of neighbor Router

BGP and BGP4+ Configuration

awplus(config-router#

neighbor 2001:db8::11 remote- Define BGP4+ neighbor Router 2, and establish a TCP session by as 200 specifying the global unicast IPv6 address (2001:db8::11) and

the AS number (200) of neighbor Router 2.

awplus(config-router)#

address-family ipv6 Enter IPv6 Address Family Configuration mode for configuring routing sessions that use IPv6 address prefixes.

awplus(config-router-af)#

neighbor 2001:db8::11 activate Activate the exchange of information to the peer (neighbor) Router 2 (2001:db8::11) and enable the exchange of IPv6 address prefix types with this neighbor. Note that other information apart from prefixes is sent in updates. This command activates the exchange of information for the peer defined.

awplus(config-router-af)#

exit-address-familyExit IPv6 Address Family Configuration mode, and return to the Router Configuration mode.

awplus(config-router)#

exit Exit the Router Configuration mode, and return to the Global Configuration mode.

Router 2

awplus#

configure terminal Enter the Global Configuration mode.

awplus(config)#

interface vlan1 Specify the interface (vlan1) to configure an IPv6 global address.

awplus(config-if)#

ipv6 address 2001:db8::11/48 Specify the IPv6 global unicast address 2001:db8::10/

48on interface vlan1.

awplus(config-if)#

exit Leave Interface Configuration mode and enter Global Configuration mode.

awplus(config)#

router bgp 200 Define the BGP4+ routing process. The number 200 specifies the AS number of Router 2.

awplus(config-router)#

bgp router-id 10.10.10.2 Configure a fixed Router ID (2001:db8::10) for the BGP4+ routing process.

	Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
2.24	AlliedWare PlusTM Operating System - Software Version 5.4.3-2.6	C613-50032-01 REV D