Allied Telesis VERSION 5.4.3-2.6 manual Bgp nexthop-trigger delay BGP and BGP4+

BGP and BGP4+ Commands

bgp nexthop-trigger delay (BGP and BGP4+)

Use this command to set the delay interval for nexthop address tracking.

Use the no variant of this command to reset the timer value to the default.

Syntax [BGP/BGP4+] bgp nexthop-trigger delay <1-100>

no bgp nexthop-trigger delay

ParameterDescription

<1-100> Nexthop trigger delay interval in seconds.

Default [BGP/BGP4+] The default nexthop delay interval is 5 seconds.

Mode [BGP/BGP4+] Global Configuration

Usage [BGP/BGP4+] This command configures the delay interval between routing table waits for nexthop delay tracking. The delay interval determines how long BGP waits after it receives the trigger from the system about one or more nexthop changes before it walks the full BGP table to determine which prefixes are affected by the nexthop changes.

Example To set the nexthop delay interval to 6 seconds, enter the command:

awplus# configure terminal

awplus(config)# bgp nexthop-trigger delay 6

Related Commands bgp nexthop-trigger-count (BGP and BGP4+) bgp nexthop-trigger enable (BGP and BGP4+)

	Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.38	AlliedWare PlusTM Operating System - Software Version 5.4.3-2.6	C613-50032-01 REV D