Allied Telesis VERSION 5.4.3-2.6, BGP4 manual Set metric, Neighbor group1 route-map rmap2

BGP and BGP4+ Commands

The following example shows the removal of the route-map name rmap2 in the neighbor route-mapcommand for the neighbor with the IPv4 address 10.10.10.1 in the IPv4 Address Family Configuration mode.

awplus# configure terminal

awplus(config)# router bgp 10

awplus(config-router)# address-family ipv4

awplus(config-router-af)#no neighbor 10.10.10.1 route-map

rmap2 in

The following example shows the configuration of the route-map name rmap2 and then the use of this map name in the neighbor route-mapcommand for the neighbor with the peer group named group1 in the Router Configuration mode.

awplus#	configure terminal
awplus(config)#	route-map rmap2 permit 6
awplus(config-route-map)#	match origin incomplete
awplus(config-route-map)#	set metric 100
awplus(config-route-map)#	exit
awplus(config)#	router bgp 10
awplus(config-router)#	neighbor group1 peer-group
awplus(config-router)#	neighbor 10.10.10.1 remote-as 10
awplus(config-router)#	neighbor 10.10.10.1 peer-group group1
awplus(config-router)#	neighbor group1 route-map rmap2 in

The following example shows the removal the route-map name rmap2 in the neighbor route-mapcommand for the neighbor with the peer group named group1 in the Router Configuration mode.

awplus#	configure terminal
awplus(config)#	router bgp 10
awplus(config-router)#	no neighbor group1 route-map rmap2 in

	Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D	AlliedWare PlusTM Operating System - Software Version 5.4.3-2.6	3.161