Allied Telesis VERSION 5.4.3-2.6 manual Network synchronization BGP and BGP4+

BGP and BGP4+ Commands

network synchronization (BGP and BGP4+)

Use this command to ensure the exact same static network prefix, specified through any of the network commands, is local or has IGP reachability before introduction to BGP or BGP4+.

Use the no variant of this command to disable this function.

Syntax [BGP/BGP4+] network synchronization

no network synchronization

Default [BGP/BGP4+] Network synchronization is disabled by default.

Mode [BGP] Router Configuration and IPv4 Address Family [ipv4 unicast] Configuration

Mode [BGP4+] IPv6 Address Family [ipv6 unicast] Configuration

Examples [BGP] The following example enables IGP synchronization of BGP static network routes in the Router Configuration mode.

awplus# configure terminal

awplus(config)# router bgp 11

awplus(config-router)# network synchronization

The following example enables IGP synchronization of BGP static network routes in the IPv4-Unicast address family.

awplus# configure terminal

awplus(config)# router bgp 11

awplus(config-router)#address-family ipv4 unicast

awplus(config-router-af)# network synchronization

Example [BGP4+] The following example enables IGP synchronization of BGP4+ static network routes in the IPv6-Unicast address family.

awplus# configure terminal

awplus(config)# router bgp 11

awplus(config-router)#address-family ipv6 unicast

awplus(config-router-af)# network synchronization

	Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
3.196	AlliedWare PlusTM Operating System - Software Version 5.4.3-2.6	C613-50032-01 REV D