Allied Telesis VERSION 5.4.3-2.6 manual Neighbor dont-capability-negotiate BGP and BGP4+

BGP and BGP4+ Commands

neighbor dont-capability-negotiate (BGP and BGP4+)

Use this command to disable capability negotiation for BGP and BGP4+.

The capability negotiation is performed by default. This command is used to allow compatibility with older BGP versions that have no capability parameters used in open messages between peers.

Use the no variant of this command to enable capability negotiation.

Syntax [BGP/BGP4+] neighbor <neighborid> dont-capability-negotiate

no neighbor <neighborid> dont-capability-negotiate

Parameter Description

<neighborid> {<ip-address><ipv6-addr><peer-group>}

<ip-address>Specify the IPv4 address of the BGP neighbor in dotted decimal, in the format A.B.C.D.

<ipv6-addr>Specify the IPv6 address of the BGP4+ neighbor, entered in hexadecimal in the format X:X::X:X.

<peer-group>Enter the name of an existing peer-group. For information on how to create peer groups, refer to the neighbor peer-group (add a neighbor) (BGP and BGP+) and neighbor route-map (BGP and BGP4+) commands.

		When this parameter is used with this
		command, the command applies on all peers in
		the specified group.
Mode [BGP/BGP4+] Router Configuration
Examples [BGP]
	awplus#	configure terminal
	awplus(config)#	router bgp 10
	awplus(config-router)#	neighbor 10.10.0.34
		dont-capability-negotiate
	awplus#	configure terminal
	awplus(config)#	router bgp 10
	awplus(config-router)#	no neighbor 10.10.0.34
		dont-capability-negotiate

	Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches
C613-50032-01 REV D	AlliedWare PlusTM Operating System - Software Version 5.4.3-2.6	3.117