Allied Telesis VERSION 5.4.3-2.6 manual Neighbor update-source BGP and BGP4+

Models: BGP4 VERSION 5.4.3-2.6

1 350
Download 350 pages 8.81 Kb
Page 283
Image 283

BGP and BGP4+ Commands

neighbor update-source (BGP and BGP4+)

Use this command to specify the source IPv4 or IPv6 address of BGP or BGP4+ packets, which are sent to the neighbor for routing updates, as the IPv4 or IPv6 address configured on the specified interface. The specified interface is usually the local loopback (lo) interface to allow internal BGP or BGP4+ connections to stay up regardless of which interface is used to reach a neighbor.

Use the no variant of this command to remove the IPv4 or IPv6 address from the interface as the source IPv4 or IPv6 address of BGP or BGP4+ packets sent to the neighbor, and restores the interface assignment to the closest interface, which is also called the best local address.

Syntax [BGP/BGP4+] neighbor <neighborid> update-source <interface>

no neighbor <neighborid> update-source

Parameter Description

<neighborid> {<ip-address><ipv6-addr><peer-group>}

<ip-address>Specify the address of an IPv4 BGP neighbor, in dotted decimal notation A.B.C.D.

<ipv6-addr>Specify the address of an IPv6 BGP4+ neighbor, entered in hexadecimal in the format X:X::X:X.

<peer-group>Enter the name of an existing peer-group. For information on how to create peer groups, refer to the neighbor peer-group (add a neighbor) (BGP and BGP+) command on page 3.144, and neighbor route-map (BGP and BGP4+) command on page 3.159. When this parameter is used with this command, the command applies on all peers in the specified group.

<interface> Specifies the local loopback interface (lo).

Default [BGP/BGP4+] Use of this command sets a default value of 2 for the maximum hop count.

Mode [BGP] Router Configuration or IPv4 Address Family Configuration for a VRF instance

Mode [BGP4+] Router Configuration

Usage [BGP/BGP4+] Use this command in conjunction with any specified interface on the router. The local loopback interface is the interface that is most commonly used with this command. The use of local loopback interface eliminates a dependency and BGP or BGP4+ does not have to rely on the availability of a particular interface for making BGP or BGP4+ peer relationships.

 

Software Reference Supplement for SwitchBlade® x8112, x908, x900 and x610 Series Switches

 

C613-50032-01 REV D

AlliedWare PlusTM Operating System - Software Version 5.4.3-2.6

3.185

Page 283
Image 283
Allied Telesis VERSION 5.4.3-2.6 manual Neighbor update-source BGP and BGP4+, Neighborid ip-addressipv6-addrpeer-group