|
|
| P R E L I M I N A R Y | AMD |
|
|
| ||
CONFIGURATION REGISTER INDEX: | 15h |
| ||
Bit | Name | Reset Value | Description |
|
|
|
|
| |
BDRN[3:0] | 0h | Baud Detect Ratio. These bits are used to set the ratio of good to |
bad baud detections which will be used as the minimum ratio to de- termine that a valid signal is present on the medium. The value in this register is treated as a radix 2 positive real number with two decimal places. The lowest practical value possible is 0.25 (=00.01) and the highest practical value is 3.75 (=11.11).
TCR22: Baud Detect Accept Count
This register is the Baud Detect Accept Count register. A
CONFIGURATION REGISTER INDEX: | 16h | ||
Bit | Name | Reset Value | Description |
|
|
|
|
Reserved | – | Reserved. Must be written as a 0. Reads of this bit produce | |
|
|
| undefined data. |
ACPT[5:0] | 00h | Accept[5:0] The value of these bits indicates the current number | |
|
|
| of good transitions detected by the baud detector. This is a |
|
|
|
TCR23: Baud Detect Fail Count
This register is the Baud Detect Fail Count register. A
CONFIGURATION REGISTER INDEX: | 17h | ||
Bit | Name | Reset Value | Description |
|
|
|
|
Reserved | – | Reserved. Must be written as a 0. Reads of this bit produce | |
|
|
| undefined data. |
FAIL[5:0] | 00h | Fail[5:0] The value of these bits indicates the current number of | |
|
|
| bad transitions detected by the baud detector. This is a |
|
|
|
TCR24: RSSI Sample Start
This register is the RSSI Sample Start register. The value in this register is used to determine when to cap- ture a sample of the RSSI input for A/D conversion dur- ing antenna diversity operation. The register value is a
measure of the time of RSSI sample relative to the an- tenna switching event. A register value of 0 means that no RSSI samples will be taken.
Am79C930 | 117 |