Maintaining tape drives
8.Remove the two screws securing the front cover to the front of the system. See the following figure.
9.Remove the front cover.
10.Disconnect the data and power cables from the back of the drive.
11.Remove the two screws that secure the drive to the chassis.
12.Slide the drive out through the front of the chassis.
13.Set the SCSI address on the new drive using the jumpers on the back of the drive. Set the tape drive to 5. See the following figure.
|
| DAT 72 |
| |||||||||
TP NC 8 4 2 1 | 8 4 2 1 |
| ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
tape_jumpers.cdr
14.Slide the replacement drive into the chassis and secure it with the screws that you removed earlier.
Issue 2.0 June 2004 129
