Avaya V880 manual Installing the XVR-100 software packages, Cd /cdrom/cdrom0, Eject cdrom

Maintaining PCI cards

Installing the XVR-100 software packages

The XVR-100 software packages must be installed after you install a new XVR-100 graphics accelerator card. If you are replacing an existing XVR-100 graphics accelerator card, you do not have to reinstall this software.

To install the XVR-100 software packages on a Sun Fire V880 system:

1.Verify that your CMS system is running CMS R3V11 by entering: pkginfo -x cms

Note:

Do not perform this procedure if your CMS system is running a later load of CMS. The software packages were installed with the Solaris operating system.

2. Verify that the XVR-100 graphics accelerator card is installed.

Note:

For information on how to install the XVR-100 graphics accelerator card, see the Sun documentation that was shipped with the card.

3.Load the CD-ROM, Sun XVR-100 FCS into the CD-ROM drive.

4.Enter:

cd /cdrom/cdrom0

5.Enter:

./install

The system installs the SUNWpfbx.u, SUNWpfbcf, SUNWpfbw, and SUNWpfbmn packages.

6.Enter:

/usr/sbin/shutdown -y -i0 -g0

The system shuts down and displays the ok prompt.

7.Enter: boot -r

8.Log into the system as root.

The system reboots and displays the # prompt.

9.Enter:

eject cdrom

Issue 2.0 June 2004 75