Avaya V880 manual Installing HSI/P software and patches, Setting up the switch link for each ACD

Maintenance

24.Enter: boot -r

This reboots the system so that it recognizes the new HSI/P cards.

Note:

Sometimes the system fails to recognize a newly installed HSI card. If this happens, the command show-devsdoes not show the HSI card and / var/adm/messages fails to recognize the card upon bootup. See the troubleshooting chapter of Avaya Call Management System Switch Connections, Administration, and Troubleshooting for information about troubleshooting HSI/P cards.

25.When the system comes back up, log in as root.

26.Enter: cfgadm

This displays the PCI card configuration after you add the card. Make sure that the new card is displayed.

27.Continue with Installing HSI/P software and patches on page 88.

Installing HSI/P software and patches

Use the following procedures in the CMS software installation, maintenance, and troubleshooting document to:

●Install the HSI/P software

●Reinstall the Solaris patches

After installing the software and patches, continue with Setting up the switch link for each ACD on page 88

Setting up the switch link for each ACD

To change the switch link administration for each ACD:

1.Enter: cmssvc

The CMS Services menu is displayed.

2.Select the run_cms option.

3.Turn off CMS.

4.Enter: cmssvc

The CMS Services menu is displayed.

88 Avaya CMS Sun Fire V880 Computer Hardware Installation, Maintenance, and Troubleshooting