Avaya V880 manual Performs a checksum of the flash Prom containing

Tools

Command	Command name	Description
number
7	controller@0,16	Tests the base backplane firmware and SSC-100 SES
		controllers.
8	controller@0,1a
9	controller@0,1c	Tests the expansion backplane firmware and SSC-100
		SES controllers. Use only on 12-disk systems.
10	controller@0,1e
11	ebus@1	Tests the PCI configuration registers, DMA control
		registers, ebus mode registers, and DMA controller
		functions.
12	flashprom@0,0	Performs a checksum of the flash PROM containing the
		OpenBoot firmware.
13	gpio@1,300600	Tests the registers of the super I/O subsystem.
14	hot plug-controller@0,	Performs a hot-plug test of the PCI slots.
		! CAUTION:
15	hot plug-controller@0,
		After the hot-plug test, the PCI cards in the
16	hot plug-controller@0,
		slots are not usable until you reset the
17	hot plug-controller@0,
		system.
18	i2c@1,2e	Tests the devices monitored by the I2C environmental
		monitoring bus (temperature sensors, fans, power
19	i2c@1,30
		supplies, system fault LEDs, thermal fault LEDs, and front
		panel key switch).
20	i2c@1,50002e
21	i2c@1,500030
22	keyboard@1	Tests the USB keyboard.
23	network@1	Tests the on-board Gigabit Ethernet (GBE) logic, including
		internal and external loopback tests.
24	network@1,1	Tests the on-board Fast Ethernet logic, including internal
		and external loopback tests.
25	pmc@1,300700	Tests the registers of the power management controller.
26	rsc-control@1,3062f8	Tests RSC hardware, including RSC serial and Ethernet
		ports.
27	rtc@1,300700	Tests the registers of the real-time clock and then tests the
		interrupt rates.
28	scsi@1	Tests the on-board SCSI controller and SCSI bus
		subsystem for internal removable media devices. Checks
		associated registers and performs a DMA transfer.

Issue 2.0 June 2004 173