Avaya V880 manual Setenv auto-boot? true Boot

Turning on the system and verifying POST

9.Enter: probe-scsi-all

This verifies that the system sees the disk drives and backplane, the tape drive, and the DVD-ROM drive. A message that is similar to the following is displayed:

/pci@8,600000/SUNW,qlc@2
LiD HA LUN			--- Port WWN ---	-----Disk description -----
0	0	0	21000004cf72f08f	SEAGATE	ST373405FSUN3660438
1	1	0	21000004cf721553	SEAGATE	ST373405FSUN3660438
6	6	0	508002000016b5b1	SUNW	SUNWGS INT FCBPL9224
3	3	0	21000004cf72114b	SEAGATE	ST373405FSUN3660438
4	4	0	21000004cf7211ae	SEAGATE	ST373405FSUN3660438

/pci@8,700000/scsi@1 Target 5

Unit 0 Removeable Tape HP C5683A C005 Target 6

Unit 0 Removeable Read Only device TOSHIBA DVD-ROM SD-M14011009 /pci@8,700000/pci@5/SUNW,1sptwo@4

10.Verify that all of the devices are recognized. If the devices are not recognized, see Troubleshooting disk drives and DVD-ROM drives on page 180 for more information.

11.When you have verified that the system recognizes all of its devices, enter the following commands:

! CAUTION:

If you fail to reset the auto-boot option, any reboots that you do in the future will stop at the boot prompt instead of proceeding through the normal boot-up process.

setenv auto-boot? true

boot

The system reboots.

Issue 2.0 June 2004 37