Maintenance

12.Insert the new graphics card into the slot on the I/O board. Make sure that the card is fully seated. See the following figure.

13.Rotate the purple PCI retaining clip over the back of the card faceplate until it snaps into place.

14.Connect the monitor cable to the card.

15.Remove the ESD wrist strap.

16.Close the left door.

17.Reattach the monitor cable.

18.Turn on any external SCSI devices, starting with the device that is farthest from the system and working toward the system.

19.Turn on the system monitor. Turn on the system.

20.When the system comes back up, log in as root.

21.Enter: cfgadm

This displays the PCI card configuration after you replace the card. Make sure that the new card is displayed.

22.If you just installed an XVR-100 graphics accelerator card, continue with Installing the XVR-100 software packages on page 75.

74 Avaya CMS Sun Fire V880 Computer Hardware Installation, Maintenance, and Troubleshooting

Page 74
Image 74
Avaya V880 manual Maintenance