Recovery procedures
9.Reinsert the HSI/P card into the slot on the I/O board. Make sure that the card is fully seated.
10.Rotate the purple PCI retaining clip over the back of the card faceplate until it snaps into place.
11.Remove the ESD wrist strap.
12.Close the left door.
13.Reattach the HSI/P quad cable.
14.Turn on any external SCSI devices, starting with the device that is farthest from the system and working toward the system.
15.Turn on the system monitor.
16.Turn on the system. Do not put the keyswitch in the locked position.
17.When the system comes back up, log in as root.
18.Test the card to see if it is now working. If the card is still not working, see Replacing an HSI/P card on page 73.
Issue 2.0 June 2004 197
