|
| Advanced GSLB configuration for IPv6 | 2 | |
TABLE 18 | GSLB policy metrics (Continued)for IPv6 |
|
| |
|
|
|
|
|
Metric |
| Default | Configuration options |
|
|
|
|
| |
Weighted site metric | Disabled. | You can disable this metric. |
| |
|
| When the weighted IP metric is | You can enable this metric and |
|
|
| enabled, the weighted site metric is | assign weights to individual sites. | |
|
| disabled. The weighted site metric is | The weight can be from 0 to 100. | |
|
| an alternative to the weighted IP | The default is 0. |
|
|
| metric. They are mutually exclusive. | Refer to “Weighted site metric” on | |
|
| When enabled, the ServerIron ADX | page 211. |
|
|
| distributes SLB traffic among GSLB |
|
|
|
| sites based on weights configured |
|
|
|
| for the sites. |
|
|
Session capacity threshold | Enabled. |
| The default value for the threshold is |
| 90%. Thus, a site ServerIron ADX is |
| eligible to be the best site only if its |
| session utilization is below 90%. |
You can disable this metric.
You can change the threshold to a value from
Refer to “To view the results of traffic distribution after configuring weighted site metrics, use the show gslob traffic site command. Refer to “Displaying results of traffic distribution for weighted sites” on page 235.” on page 213.
Connection load | Not supported. | The connection load policy metric is |
|
| not supported in the current |
|
| implementation of GSLB for IPv6. |
|
|
|
Active bindings | Disabled. | You can enable and disable this |
| When enabled, the ServerIron ADX | metric. |
| selects an IP address with the | Refer to “Active bindings metric” on |
| highest number of active bindings | page 214. |
| as the best IP address for the client. |
|
|
|
|
Not supported. | The active and passive | |
|
| time policy metrics are not |
|
| supported in the current |
|
| implementation of GSLB for IPv6. |
|
|
|
Geographic location | Enabled. | You can disable this metric. |
| The GSLB controller selects an IP | Refer to “Geographic location |
| address based on the geographic | metric” on page 216. |
| location of the server. |
|
Available session capacity | Enabled. |
| The default tolerance is 10%. |
| When comparing sites based on the |
| session table utilization, the GSLB |
| ServerIron ADX will prefer one site |
| over the other only if the difference |
| in session table utilization is greater |
| than the tolerance percentage. |
You can disable this metric.
You can change the tolerance to a value from
Refer to “Available session capacity metric” on page 218.
ServerIron ADX Global Server Load Balancing Guide | 205 |
|
