If you selected Ether Talk, press the scroll button ( or ) to change the setting to "On" (enable) or "Off" (disable).

6. Press <Select> to save the selection.

Configuring TCP/IP

Static Addressing: TCP/IP address is assigned manually by the system administrator.

Dynamic Addressing BOOTP/DHCP(default): TCP/IP address is assigned automatically by a DHCP or BOOTP server on your network.

Static Addressing

To enter the TCP/IP address from your multi-function printer's operator panel, take the following steps:

1.Press <Menu> until you see "Network Setup" on the bottom line of the display.

2.Press the scroll button ( or ) until "Configuration" displays on the bottom line. Press <Select>.

3.Press the scroll button ( or ) to display "TCP/IP" and press <Select>.

The first available menu item, "Manual", appears on the bottom line and press <Select>.

4.The first available menu item, "IP Address" displays on the bottom line.

5.Press <Select> to access the IP Address menu.

An IP address consists of 4 bytes.

6.Enter the numbers from the keypad and use the scroll button ( or ) to move between octets and press <Select>.

7.Repeat Step 5 to complete the address from the 1st byte to the 4th byte.

8.To select other parameters, such as the Subnet Mask, Gateway or Primary DNS, press <Return>, then use the scroll button ( or ). Press <Select>.

9.Repeat steps 5 through 8 to configure the other TCP/IP parameters.

Dynamic Addressing (BOOTP/DHCP)

Page 128
Image 128
Dell 1600n manual Configuring TCP/IP, Static Addressing