Dell 1600n FCC Notices (U.S. Only)

Most Dell computers are classified for Class B environments. However, the inclusion of certain options can

change the rating of some configurations to Class A. To determine the electromagnetic classification for your

computer or device, see the following sections specific for each regulatory agency. Each section provides

country-specific EMC/EMI or product safety information.

FCC Notices (U.S. Only)

Most Dell computers are classified by the Federal Communications Commission (FCC) as Class B digital

devices. To determine which classification applies to your computer, examine all FCC registration labels

located on the bottom, side, or back panel of your computer, on card-mounting brackets, and on the cards

themselves. If any one of the labels carries a Class A rating, your entire computer is considered to be a Class

A digital device. If all labels carry an FCC Class B rating as distinguished by either an FCC ID number or the

FCC logo, ( ), your computer is considered to be a Class B digital device.

Once you have determined your computer's FCC classification, read the appropriate FCC notice. Note that

FCC regulations provide that changes or modifications not expressly approved by Dell could void your

authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference.

This device must accept any interference received, including interference that may cause undesired

operation.

This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used in accordance with the manufacturer's

instruction manual, may cause harmful interference with radio communications. Operation of this equipment

in a residential area is likely to cause harmful interference, in which case you will be required to correct the

interference at your own expense.

This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the manufacturer's instruction manual, may cause

interference with radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, you are encouraged to try to correct the

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.