Understanding Menus

Page 28 of 61

To specify the communication speed and the duplex settings of Ethernet. The change becomes effective after the multifunction printer is turned off and then on again.

Values:

Detects the Ethernet settings automatically.

Auto*

Uses 10base-T half-duplex.

10 Base Half

Uses 10base-T full-duplex.

10 Base Full

Uses 100base-TX half-duplex.

100 Base Half

Uses 100base-TX full-duplex.

100 Base Full

TCP/IP

Purpose:

To specify the TCP/IP settings for the wired network. The change becomes effective after the multifunction printer is turned off and then on again.

Values:

 

1

Dual Stack

Uses both IPv4 and IPv6 to set the IP address.

IP Mode*

 

 

 

 

 

 

 

IPv4 Mode

Uses IPv4 to set the IP address.

 

 

 

 

 

 

 

 

 

 

IPv6 Mode*3

Uses IPv6 to set the IP address.

 

 

 

IPv4

 

Get IP Address

AutoIP*

Automatically sets the IP address.

 

 

 

 

 

 

 

 

 

 

BOOTP

Uses BOOTP to set the IP address.

 

 

 

 

 

 

 

 

 

 

 

 

RARP

Uses RARP to set the IP address.

 

 

 

 

 

 

 

 

 

 

 

 

DHCP

Uses DHCP to set the IP address.

 

 

 

 

 

 

 

 

 

 

 

 

Panel

Enables the IP address entered on the operator panel.

 

 

 

 

 

 

 

 

 

 

 

IP Address

Sets the IP address allocated to the printer by using the

 

 

keys on the operator panel.

 

 

 

 

 

 

 

 

 

 

 

Subnet Mask

Sets the subnet mask.

 

 

 

 

 

 

 

 

 

 

Gateway Address

Sets the gateway address.

 

 

 

 

 

 

 

 

mk:@MSITStore:C:\Users\14JMIS~1\AppData\Local\Temp\Rar$DIa0.409\UsersGuide.ch... 2/29/2012

Page 162
Image 162
Dell 3115CN manual Tcp/Ip