4. Hold both sides of the transfer belt unit with both hands and pull up the left side of the unit until the
peg on the left side comes out of the groove. Then, shift the transfer belt unit to the right and remove
the unit from the multifunction printer.
Installing a New Transfer Belt Unit
1. Unpack a new transfer belt unit.
2. Insert the left peg into the corresponding left side belt unit hole, then align the right peg with the
groove, and then push down on the right side of the transfer belt unit to seat into place.
3. Close the transfer belt unit by pulling it down until it clicks.
CAUTION: Do not touch the inside of the multifunction printer. Some parts may be hot. Allow
time for the multifunction printer to cool before attempting to remove parts in this area.
Page
19
of
24
Maintaining Your Multifunction Printer
2/
29/
2012
mk:@MSITStore:C:\Users\14JMIS~1\AppData\Local\Temp\Rar$DIa0.409\UsersGuide.ch