Understanding Menus

Page 36 of 61

IP Filter*1

Sets the IP address for Filter n.

No. n/Address (n is 1-5.)

Sets the mask for Filter n.

No. n/Mask (n is 1-5.)

Disable the IP Filter feature for Filter n.

No. n/Mode (n is 1-5.) Off*

Accepts an access from specified IP address.

Accept

Rejects an access from specified IP address.

Reject

*1 This item is only available for LPD or Port9100.

Initialize NVM

Purpose:

To initialize wireless network data stored in NVRAM.

Adobe Protocol

Purpose:

To specify PostScript communication protocol for each interface. You can configure Adobe Protocol settings for the wireless network. The change becomes effective after the multifunction printer is turned off and then on again.

Values:

Auto

Used when auto-detecting the PostScript communication protocol.

 

 

 

Standard

Used when the communication protocol is in ASCII interface.

 

 

 

BCP

Used when the communication protocol is in binary format.

 

 

 

TBCP*

Used when the communication protocol supports both ASCII and binary data to switch between

them according to the specified control code.

 

 

 

Binary

Used when no special processing is required.

 

 

 

Parallel Settings

The Parallel Settings menu can be adjusted to configure the parallel interface.

NOTE: Values marked by an asterisk (*) are the factory default menu settings.

ECP

mk:@MSITStore:C:\Users\14JMIS~1\AppData\Local\Temp\Rar$DIa0.409\UsersGuide.ch... 2/29/2012

Page 170
Image 170
Dell 3115CN manual Parallel Settings