Dell 3115CN manual Protocol

Understanding Menus Page 33 of 61

Purpose:

To specify the TCP/IP settings for the wireless network. The change becomes effective after the printer is turned off and then on again.

Values:

IP Mode*1	Dual Stack		Uses both IPv4 and IPv6 to set the IP address.
	IPv4 Mode		Uses IPv4 to set the IP address.
	IPv6 Mode*3		Uses IPv6 to set the IP address.
IPv4	Get IP Address	AutoIP*	Automatically sets the IP address.
		BOOTP	Uses BOOTP to set the IP address.
		RARP	Uses RARP to set the IP address.
		DHCP	Uses DHCP to set the IP address.
		Panel	Enables the IP address entered on the operator panel.
	IP Address		Sets the IP address allocated to the printer by using the
			keys on the operator panel.
	Subnet Mask		Sets the subnet mask.
	Gateway Address		Sets the gateway address.
Reset IPsec*2			Disables IPsec.

*1 Only displayed when an optional multi-protocol card is installed on the printer.

*2 Only displayed when IPsec is enabled.

*3 This mode is available only when firmware version 200706291103 or later and network (MPC) firmware version 16.03 or later are installed. Since you cannot set IPsec in Windows Vista in this mode, use the Dell Printer Configuration Web Tool. The Get Information from Printer function on the Options tab of the printer driver is not available when using this mode.

Protocol

Purpose:

To enable or disable each item. The change becomes effective after the multifunction printer is turned off and then on again.

Values:

mk:@MSITStore:C:\Users\14JMIS~1\AppData\Local\Temp\Rar$DIa0.409\UsersGuide.ch... 2/29/2012