Maintaining Your Multifunction Printer | Page 22 of 24 |
Entering Values
Using the operator panel, enter the values that you found in the color registration chart to make adjustments.
1.Press 
until >SETUP appears, and then press 
.
2.Press 
until >Admin Menu appears, and then press 
.
3.Press 
until >Maintenance appears, and then press 
4.Press 
until >Color Reg Adjust appears, and then press 
5.Press 
until >Enter Number appears, and then press 
The cursor is located at the first digit of the Enter Number.
6.Press 
or 
until you reach the value (for example, +3) displayed on the chart.
7.Press 
once and move the cursor to the next value.
8.Repeat steps 6 and 7 to enter all of the digits of the Enter Number, and then press 
9.Press 
until >ColorRegi Chart appears, and then press 
. The color registration chart is printed with the new values.
10.Color registration adjustment is complete when the straightest Y (Yellow), M (Magenta), and C (Cyan) lines are next to the 0 line.
CAUTION: After printing the color registration chart, do not turn off the multifunction printer until the printer motor has stopped running.
NOTE: If 0 is not next to the straightest lines, determine the values and adjust the multifunction printer again.
Cleaning the scanner
Keeping the scanner clean helps ensure the best possible copies. Dell recommends cleaning the scanner at the start of each day and during the day, as needed.
1.Slightly dampen a soft
2.Open the document cover.
mk:@MSITStore:C:\Users\14JMIS~1\AppData\Local\Temp\Rar$DIa0.409\UsersGuide.ch... 2/29/2012
