Dell 3115CN manual IP Filter IPv4, Initialize NVM, Adobe Protocol

Understanding Menus Page 31 of 61

Ethernet II

Uses the IEEE802.3 frame type.

Ethernet 802.3

Uses the IEEE802.2 frame type.

Ethernet 802.2

Use the SNAP frame type.

Ethernet SNAP

NOTE: The IPX/SPX menu is only displayed when an optional multi-protocol card is installed on the printer and the optional wireless printer adapter is not installed on the card.

IP Filter (IPv4)

Purpose:

To specify that data received from certain IP addresses through the wired network is blocked. You can set up to five IP addresses. The change becomes effective after the printer is turned off and then on again.

Values:

Filter*1

Sets the IP address for Filter n.

No. n/Address (n is 1-5.)

Sets the mask for Filter n.

No. n/Mask (n is 1-5.)

Disable the IP Filter feature for Filter n.

No. n/Mode (n is 1-5.) Off*

Accepts an access from specified IP address.

Accept

Rejects an access from specified IP address.

Reject

*1 This item is only available for LPD or Port9100.

Initialize NVM

Purpose:

To initialize wired network data stored in NVM. After executing this function and rebooting the printer, all wired network settings are reset to their default values.

Adobe Protocol

Purpose:

To specify PostScript communication protocol for each interface. You can configure the Adobe Protocol settings for the wired network. The change becomes effective after the printer is turned off and then on again.

Values:

mk:@MSITStore:C:\Users\14JMIS~1\AppData\Local\Temp\Rar$DIa0.409\UsersGuide.ch... 2/29/2012