Dell 3115CN manual Protocol, Lpd

Understanding Menus Page 29 of 61

Reset IPsec*2

Disables IPsec.

*1 Only displayed when an optional multi-protocol card is installed on the printer.

*2 Only displayed when IPsec is enabled.

*3 This mode is available only when firmware version 200706291103 or later and network (MPC) firmware version 16.03 or later are installed. Since you cannot set IPsec in Windows Vista in this mode, use the Dell Printer Configuration Web Tool. The Get Information from Printer function on the Options tab of the printer driver is not available when using this mode.

Protocol

Purpose:

To enable or disable each item. The change becomes effective after the printer is turned off and then on again.

Values:

LPD	Enable*	Enables the LPD port.
	Disable	Disables the LPD port.
Port9100	Enable*	Enables the Port9100 port.
	Disable	Disables the Port9100 port.
IPP*1	Enable*	Enables the IPP port.
	Disable	Disables the IPP port.
1	Enable*	Uses TCP/IP for SMB.
SMB TCP/IP*
	Disable	Does not use TCP/IP for SSB.
1	Enable*	Uses NetBEUI for SMB.
SMB NetBEUI*
	Disable	Does not use Net BEUI for SMB.
FTP	Enable*	Enables the FTP port.
	Disable	Disables the FTP port.
NetWare IP	Enable*	Enables the IP.

mk:@MSITStore:C:\Users\14JMIS~1\AppData\Local\Temp\Rar$DIa0.409\UsersGuide.ch... 2/29/2012