![](/images/new-backgrounds/1119801/119801153x1.webp)
TM-L90/TM-L90 with Peeler Technical Reference Guide
2.12 Operating Mode (Panel Switch Operation)
In order to check the setting condition of the printer, it has the
2.12.1 Self Test Mode
In self test mode, following items are checked and printed out:
•Control circuit functions
•Printer mechanisms
•Print quality
•Control software ROM version
•DIP switch settings
•Memory switch setting
•Paper layout setting
Use the following procedure to start a self test.
With TM-L90
1.First, open the roll paper cover; then close the roll paper cover while pressing and holding down the FEED button until the ERROR LED flashes. The printer prints out the various printer states.
2.When all printer states have been printed, make sure that the following message is displayed and the PAPER OUT LED flashes.
"If you want to continue
3.To start a test print, press the FEED button when the printer is in the self test wait mode.
4.Check that the following has been printed.
"*** completed ***"
This indicates that the printer has been initialized and made the transition to the normal mode.
Rev. B | Setup |