TM-L90/TM-L90 with Peeler Technical Reference Guide

4.3 Setting of Paper Width

With the TM-L90 / TM-L90 peeler specification, you can set paper width to 38 to 70 mm or 80 mm.You can select the paper width by using memory switch setting mode (See “Operating procedure of Memory Switch Settings” on page 2-27.When you'd like to set other paper width that can't be selected in the memory switch setting mode, do the setting by using memory switch setting utility (See TM Printer Memory Switch Setup Utility” on page 4-7) or ESC/POS commands.

Note:

Paper width is not set automatically by auto paper layout settings. You need to do paper width setting before setting auto paper layout.

4.4 Print Density

It is recommended to set print density according to paper type for adequate print quality and ensuring reliability. If the set density exceeds what is needed, it may lead to printer head dirt and blank dot printing. Adjust the print density as needed using the memory switch setting mode or memory switch setting utility.

Original paper number and density level

Roll Paper No.

Original Paper No.

Density Level

 

 

 

 

P350

90%

 

 

 

 

KF50

95%

 

 

 

ENTPC series

TF60KS-E, TF50KS-E, PD750R

100%

ENTPD series

 

 

 

 

 

ENTPE series

PD160R, TF11KS-ET

105%

 

 

 

ENTLA series

--

130%

ENTLB series

 

 

 

 

 

4.5 Print Speed

Default setting is normal print speed (120 mm/s maximum). High-speed printing (150 mm/s maximum) is selectable when the specified paper is selected.

Adjust the print speed as needed using the memory switch setting mode or memory switch setting utility.

4.5.1 Paper to use for high speed

If any one of the following types of thermal paper is used, the customized value setting can be used to set the maximum print speed to 150 mm/s {5.91"/s} (level 9):

ENTLA series

TF60KS-E

Rev. B

Application Development Information 4-11

Page 99
Image 99
Epson L90 manual Setting of Paper Width, Print Density, Print Speed, Paper to use for high speed