Epson manual TM-L90 peeler specification

			TM-L90/TM-L90 with Peeler Technical Reference Guide
6.3.2 TM-L90 peeler specification
	Life	Labels (single color)	Issues 1,000,000 labels
			(With feed direction label length of 25.4 {1 inch} to 63.5 mm {2.5
			inch}. Equivalent to a travel distance of about 30 to 70 km. When
			printing labels in excess of 63.5 mm, product lifetime in number of
			labels comes after a travel distance of 70 km)
		Receipts (single color)	20,000,000 lines printed (with 1 line at 3.75 mm)
			(Assuming repeated printing of 10 lines with paper thickness of 75
			µm or less and 15 line feed. Equivalent to a travel distance of about
			120 km)
		Labels (2- color)	Issues 500,000 labels
			(With feed direction label length of 25.4 {1 inch} to 63.5 mm {2.5
			inch}. Equivalent to a travel distance of about 15 to 35 km
		Receipts (2- color)	10,000,000 lines printed (with 1 line at 3.75 mm)
			(Assuming repeated printing of 10 lines with 15 line feed. Equivalent
			to a travel distance of about 60 km)
		Thermal head	150 million pulses
	MTBF		360,000 hours
			(Using receipts (single color) during the product lifetime. Failure
			means random failure in the random failure period)
	MCBF		70,000,000 lines printed
			(Using receipts (single color) during the product lifetime. Indicates
			the overall mean time between failures including wear-out failure
			and random failure up to product lifetime of 20 million lines printed)
	Vibration		When packed: Frequency:	5 to 55 Hz
	resistance		Acceleration:	Approximately 19.6 m/s2 {2 G}
			Sweep:	10 minutes (half cycle)
			Duration:	1 hour
			Directions:	x, y, and z
			No external or internal damage should be found after the vibration
			test, and the unit should operate normally.
	Impact		When packed: Package:	EPSON standard package
	resistance		Height:	60 cm {23.62"}
			Directions:	1 corner, 3 edges, and 6 surfaces
			No external or internal damage should be found after the drop test,
			and the unit should operate normally.
			When unpacked:Height:	5 cm {1.97"}
			Directions:	Lift one edge and release it
				(for all 4 edges).
			When the printer is not printing, no external or internal damage
			should be found after the drop test.
	Acoustic		Approximately 53 dB (ANSI bystander position)
	noise		NOTE:The value as shown above is measured when the EPSON
	(operating)		evaluation printing pattern is used. This value may be
			different, depending on the paper to be printed, the print
			duty, or the print conditions, such as the print speed or the
			print density.

The values in the above table are based on use of EPSON specified paper.

Depending on the paper, paper dust and adhesive may stick to the platen, head, and peeler unit.

Rev. B Product Specifications 6-7