Fluke PM-3370B SENSeSWEepREALtimeSTATe, Real-time mode switched off Real-time mode switched on

4 - 82 COMMAND REFERENCE

SENSe:SWEep:REALtime[:STATe]

Syntax: SENSe:SWEep:REALtime[:STATe] <Boolean>

Query form: SENSe:SWEep:REALtime[:STATe]?

Response: 0 1

0Real-time mode switched off.

1Real-time mode switched on.

Description:

Switches the ’real- time’ mode of the acquisition on or off. If the ’real-time’ sampling mode is switched on, the MTB range is limited to sequential sampling from 250 nanoseconds through 200 seconds per division (for MTB ranges, refer to the SENSe:SWEep:TIME command). In the analog mode error -221 "Settings conflict;Digital mode required" is generated.

After a *RST command, the ’real-time’ mode is switched off.

Example:
Send → *RST	Resets the instrument.
Send → SENSe:SWEep:REALtime ON	Sets real-time sampling on.
Send → TRIGger:SOURce INTernal1;LEVel .1;SLOPe EITHer
Sets the following trigger settings:	source = internal channel 1
	level = 0.1V
Send → INITiate	slope = either pos. or neg.
	Initiates a single acquisition.
Send → READ:AC?	Reads AC-RMS.
Read ← <AC-RMS voltage>

Front panel compliance:

The SENSe:SWEep:REALtime command is the remote equivalent of the front panel REALTIME ONLY option of the TB MODE menu.