Fluke PM-3370B, PM-3380B, PM-3390B MEASure?, Channellist =, Measurefunction measureparameters

COMMAND REFERENCE 4 - 67

MEASure?

Syntax:	MEASure[:VOLTage]<measure_function>?
	[[ (<voltage_parameters>),] <measure_parameters>]
		[,<channel_list>]
	<voltage_parameters> = [<expected_voltage> [,<resolution>]]
	<expected_voltage> = <NRf> DEFault
	Specifies the voltage that is expected at the input.
	<resolution> = <NRf> DEFault
	This parameter may be added for reasons of
	compatibility with similar programs for other
	instruments. It would specify the resolution of the result
	when a voltage measurement is to be executed.
	Because the CombiScope has a fixed resolution, this
	parameter is ignored during execution.
	Both voltage parameters must be omitted when the
	:VOLTage node of the command is defaulted.
	<channel_list> =	[(@1)] (@2) (@3) (@4)
	Specifies the input channel number at which the
	characteristic is to be measured.
	Note:	@3 and @4 not applicable for PM33x0B.
<measure_function> <measure_parameters>
:AC	No parameters. Measures the RMS value of the AC
	component. The RMS value is expressed in volts.
:AMPLitude	No parameters. Measures the amplitude of a waveform.
	The amplitude is the difference between the HIGH and
	LOW values as shown in figure 3.2. The amplitude is
	expressed in volts.
[:DC]	No parameters. Measures the DC component. The DC
	component is expressed in volts.