Fluke PM-3370B, PM-3380B, PM-3390B TRIGgerSEQuence1SLOPe TRIGgerSTARtSLOPe, Pos, Neg, Eith

4 - 122 COMMAND REFERENCE

TRIGger[:SEQuence[1]]:SLOPe

TRIGger[:STARt]:SLOPe

Syntax: TRIGger[:SEQuence[1]]:SLOPe POSitive NEGative EITHer

Alias: TRIGger[:STARt]:SLOPe POSitive NEGative EITHer

POSitive	Positive trigger edge.
NEGative	Negative trigger edge.
EITHer	Triggering is done at a positive and at a negative
	edge.

Query form: TRIGger[:SEQuence[1]]:SLOPe?

TRIGger[:STARt]:SLOPe?

Response: POS NEG EITH

POS	Positive trigger edge.
NEG	Negative trigger edge.
EITH	Trigger edge is both positive and negative.

Description:

Controls the trigger edge (slope) to be detected. The command sets the trigger slope and the query returns the trigger slope. The dual slope mode (EITHer) is only possible, if the following selections are valid:

-	the digital mode	INSTrument DIGital
-	the real-time mode	SENSe:SWEep:REALtime ON
-	the ’single-shot’ mode	INITiate:CONTinuous OFF
- the trigger source is INTernal		TRIGger:SOURce INTernal1234

After a *RST command, the trigger slope is POSitive.