Fluke PM-3394B, PM-3380B End node settings, Channel 1/2/3/4 settings, Probe scale settings

SUMMARY OF SYSTEM SETTINGS E - 1

APPENDIX E

SUMMARY OF SYSTEM SETTINGS

The following table identifies which instrument settings belong to which node.

NODE NR:	SPECIFICATION:
0	End node settings	length = 1 byte
	zero
1 2 3 4	Channel 1/2/3/4 settings	length = 8 bytes
	attenuation, channel on/off, input coupling DC/AC/grounded, invert
	on/off, input impedance 50Ω/1MΩ, attenuation mode
	continuous/discrete, Y_offset_position.
14	Probe scale settings	length = 24 bytes
	probe_correction_factors CH1/2/3/4, probe_scale bits, probe_unit
	CH1/2/3/4, probe_scale_factors CH1/2/3/4.
15	Common vertical settings	length = 6 bytes
	add CH1+CH2, add CH3+CH4, display mode alternate/chopped,
	automatic display on/off, bandwidth limiter on/off, averaging on/off,
	envelope mode on/off, averaging factor, vertical magnify factor.
16	Horizontal settings	length = 9 bytes
	x-deflection on/off, reset on/off, acquisition lock on/off, scope mode
	digital/analog, peak detection on/off, horizontal mode: auto,
	triggered, single-shot, multiple-shot, x-deflection source
	CH1/2/3/4/line, digital magnify factor + analog magnify on/off,
	acquisition length factor, x-position.
17	Main timebase settings	length = 26 bytes
	timebase, trigger mode: edge, TV, pattern, state, glitch, intensified
	on/off, main timebase on/off, trigger slope pos/neg, TV trig mode

field1/field2/line, noise suppression on/off, mtb mode continuous (var. steps)/discrete (1-2-5 steps), peak-peak trig on/off, triggered on/off, armed on/off, Vpp trig slope, roll mode stop on trig/continuous, autoset trigger gap on/off, roll mode on/off, real- time only on/off, dual slope triggering on/off, trigger level, trigger source CH1/2/3/4, composite, line, external, trigger delay value, trigger coupling AC, DC, LF reject, HF reject, TV-system PAL, HDTV, NTSC, SECAM, pattern glitch condition ENTER, EXIT, RANGE, >T1, <T2, trigger pattern CH1/2/3/4, TV line number, pattern/glitch trigger time T1/2.