Fluke PM-3384B, PM-3380B, PM-3390B TRIGgerSEQuence1HOLDoff TRIGgerSTARtHOLDoff, Response NR3

COMMAND REFERENCE 4 - 119

TRIGger[:SEQuence[1]]:HOLDoff

TRIGger[:STARt]:HOLDoff

Syntax: TRIGger[:SEQuence[1]]:HOLDoff <NRf> MINimum MAXimum

Alias: TRIGger[:STARt]:HOLDoff <NRf> MINimum MAXimum

<NRf>	The hold-off value expressed in percent.
	The range is from 0.00 (MINimum = 0 %) to 1.00
	(MAXImum = 100 %).

Query form: TRIGger[:SEQuence[1]]:HOLDoff? [MINimum MAXimum] TRIGger[:STARt]:HOLDoff? [MINimum MAXimum]

Response: <NR3>

<NR3> The hold-off value in percent.

Description:

The hold-off value specifies the hold-off time after each Main Time Base sweep, during which the MTB event detector is inhibited from acting on any new trigger. For a specification of the minimum and maximum hold-off time, refer to the Reference Manual supplied. In the digital mode the hold-off time is used to process previously captured data.

After a *RST command, the hold-off value is 0 %.

Example:
Send → TRIGger:HOLDoff 0.5	Hold-off becomes 50 %.

Front panel compliance:

The TRIGger:HOLDoff command is the remote equivalent of the front panel HOLD OFF knob.