Fluke PM-3394B Query form SENSeSWEepTIME? MINimum MAXimum, MTB values in the digital mode

COMMAND REFERENCE 4 - 83

SENSe:SWEep:TIME

Syntax: SENSe:SWEep:TIME <NRf> MINimum MAXimum

<NRf>	The sweep time in seconds.
MINimum	Selects the minimum possible sweep time.
MAXimum	Selects the maximum possible sweep time.

Query form: SENSe:SWEep:TIME? [MINimum MAXimum]

Response: <NR3>

<NR3> The sweep time expressed in seconds.

If MINimum was specified, the minimum possible value is returned.

If MAXimum was specified, the maximum possible value is returned.

Description:

This command sets the time base of a sweep for all input channels in seconds. The time base of a sweep is the time duration of one complete trace acquisition. Together with the number of trace points (TRACe:POINts), the SENSe:SWEep:TIME command determines the Main Time Base (MTB). The MTB is expressed in seconds per division. Since there are 50 points in each division (horizontally), the MTB can be calculated from the following equation:

MTB = 50 * SENSe:SWEep:TIME / (TRACe:POINts - 1)

In the analog mode the main time base is put in the variable mode. In the digital mode the sweep times are limited by permitted MTB values according to the following table:

s	ms	μs	ns
	500	500	500
			250
200	200	200	200
100	100	100	100
50	50	50	50	not valid
20	20	20	20	in the real
10	10	10	10	time mode
5	5	5	5
2	2	2	2
1	1	1
Note:	If 2 or more channels are switched on in the real time mode, the time
	base range is limited to 10 μs (non-alternating time base).

Table 4.2 MTB values in the digital mode