HP CM1015 manual Cartridge-out override, On-going operation

Cartridge-out override

The HP Color LaserJet CM1015/CM1017 MFP displays an Order supplies message when a cartridge is running low and a Replace supplies message when a cartridge has been depleted. To ensure optimal print quality, HP recommends replacing a cartridge when the Replace supplies message is displayed. Replacing the cartridge at this point can help prevent waste of media or other cartridges when one cartridge produces poor print quality.

The Cartridge-out override feature allows the MFP to continue to use a cartridge that has reached the recommended replacement point.

WARNING! Using override can result in unsatisfactory print quality and unavailability of certain features (such as toner remaining information).

WARNING! All print defects or supply failures incurred when an HP supply is used in override are not considered defects in materials or workmanship in the supply under HP's Print Cartridge Limited Warranty Statement. For Warranty information, see Print Cartridge Limited Warranty Statement.

Configuration

Cartridge-out override can only be enabled from the control-panel menu.

1.From the main menu, press the navigation arrows to choose System setup and press OK.

2.Press the navigation arrows to choose Print quality and press OK.

3.Press the navigation arrows to choose Replace supplies and press OK.

4.Press the navigation arrows to choose Override out and press OK.

5.Press OK.

If Stop at out is chosen, the MFP stops printing when a cartridge reaches the recommended replacement point. When Override out is selected, the MFP continues printing when a cartridge reaches the recommended replacement point. The factory default setting is Stop at out.

On-going operation

Override can be enabled or disabled at any time, and does not have to be re-enabled for each cartridge. The MFP automatically continues printing when a cartridge reaches recommended replacement. The MFP displays the message Replace supply. Override in use. while a cartridge is used in Override mode. When the cartridge is replaced with a new supply, Override de-activates until another cartridge reaches recommended replacement.

ENWW Cartridge-out override 163