NOTE The change in the setting remains active for about two minutes after the copy job has been completed. During this time, Settings=Custom appears on the device control- panel display.
Reduce or enlarge copies
To change the default copy size
NOTE The default copy size is the size to which copies are normally reduced or enlarged. When keeping the factory default size setting of Original=100%, all copies are the same size as the original document.
1.On the control panel, press Menu.
2.Press the navigation arrows to select Copy setup, then press OK.
3.Press the navigation arrows to select Default Reduce/Enlarge, then press OK.
4.Press the navigation arrows to select one of these options for reducing or enlarging copies:
●Original=100%
●A4 > Letter=94%
●Letter > A4=97%
●Full Page=91%
●Fit to page
●Custom: 25 to 400%
When Custom: 25 to 400% is selected, type in the percentage of the original size that you normally want for copies.
5.Press OK to save the selection.
Change copy size for the current job
1.On the device control panel, press Reduce/Enlarge.
2.Press Left arrow or Right arrow to select the size to reduce or enlarge the copies. Select one of these sizes:
●Original=100%
●A4 > Letter=94%
●Letter > A4=97%
●Full Page=91%
●Fit to page
●Custom: 25 to 400%
3.Press Start Copy Black or Start Copy Color to save the selection and immediately start the copy job, or press OK to save the selection without starting the job.
74 Chapter 8 Copy | ENWW |
