Intel 460GX 11.2.8.1Global Control and Enable

LPC/FWH Interface Configuration

11.2.8.1Global Control and Enable

Address Offset:		1A-1Bh
Attributes:		Read/Write
Default Value:		Bits 8 Undefined, Bit 3 ‘1’, All other bits ‘0’
Size:		16 bits
Bit		Description
15:13	Reserved.
12	ACPI_TMR_EN: If not using ACPI (SCI) mode, as indicated by SCI_EN not set, then the
	ACPI_TMR_EN bit can be set to cause an SMI#. SMI will be generated if this bit, SMI_EN and
	TMROF_EN are set, and SCI_EN is not set.
11	Reserved.
10	APMC_EN: Software sets this bit to 1 to enable SMIs based upon accesses to the APM control
	port at B2h in I/O space.
9	ECC_EN: This bit is used to enable the generation of SMI when the ECC_STS bit in the Global
	Status Register is set.
8	EXTSMI_EN: This bit is used to enable the setting of the EXTSMI_STS bit to generate an SMI
	event (SMI# or Wake/Break). The EXTSMI_STS bit is set anytime a GPIO is programmed as an
	input, is routed to generate an SMI#, and has its register bit set. Upon power up, this bit is
	undefined.
7	SWSMI_TMR_EN: Software sets this bit to a 1 to start the Software SMI# Timer. When the 128
	ms timer expires (±4.57 ms), it will generate an SMI# and set the SWSMI_TMR_STS bit. The
	SWSMI_TMR_EN bit will remain at 1 until software sets it back to 0. Once the timer has been
	started, if SWSMI_TMR_EN bit is set to 0 before the timer expires, the timer will not expire, and
	the SMI# will not be generated. The default for this bit is 0.
6	1MIN_EN: Enables the 1 minute timer (±1.17s) to count. When it reaches its timeout, it will
	generate an SMI#.
5	Reserved.
4	BIOS_EN: Enables the generation of SMI# when ACPI software writes a 1 to the GBL_RLS bit.
3	EOS: End of SMI. This bit controls the arbitration of the SMI signal to the processor. When this bit
	is set, SMI# will be deasserted. Also this bit will be automatically cleared once IFB asserts SMI#
	low. In the SMI handler, the processor should clear all pending SMIs (by servicing them and then
	clearing their respective status bits) and then setting this bit and resuming. This will allow the SMI
	arbiter to re-assert SMI upon detection of an SMI event and the setting of a SMI status bit.
2	THRM_POL: This bit controls the polarity of the THRM# pin needed to set the THRM_STS bit.
	When the THRM_POL bit is LOW then a HIGH value on the THRM# signal will set the
	THRM_STS bit.
1	BIOS_RLS: Enables the generation of an SCI interrupt for ACPI software when a one is written to
	this bit position by firmware software. This bit always reads a zero.
0	SMI_EN: When set, this bit enables the generation of SMIs in the system upon any enabled SMI
	event. The exception is when the BIOS Write Enable bit of the BOISEN register is set, an SMI is
	generated regardless of the state of the SMI_EN bit. This bit is reset by a PCI reset event.

11-36 Intel® 460GX Chipset Software Developer’s Manual