Connection and setup
First Installation
Before you start to use the UFS 922, read the chapters “Safety instructions - Important information”, “Important information” and “Connection and setup” through to the “First Installation” section.
Do not connect the unit to the mains until all installation work has been properly carried out.
The guidance provided in the “First Installation” section assumes that the receiver has been properly connected as per the “Safety instructions - Important information”, “Important information” and “Connection and setup” chapters through to the “First Installation” section.
Required buttons on remote control for first installation:
... | Numerical input | (green) | Proceed to next step in first installation |
|
|
|
|
(red) | Go back one step in the first installation | | Confirm the changed values/setting |
| Select/change individual menu |
|
|
parameters, navigation |
|
| |
|
|
| |
|
|
|
|
| Cancel input, go back |
|
|
|
|
|
|
First switch your TV set on and select the AV channel slot you have used to connect the UFS 922 to your TV set. Start up the UFS 922 by switching on the power switch on the rear of the unit. The following display appears:
Always pay attention to the bar at the bottom of the
Use the buttons to select the desired menu language for your UFS 922 and confirm your selection using the
button. The selected language is indicated with a tick. The following languages are available: German, English, French, Italian, Spanish, Czech, Dutch, Polish, Turkish and Russian.
Press the (green) button to move to the next menu.
14
