Connection and setup

The following configuration options are available for:

Tuner 2 Connection type “Loopthrough”:

All settings are made on tuner 1. The second tuner is fed from the looped through output of the first tuner. Available settings for tuner 1 are: “DiSEqC™1.0”, “DiSEqC™1.1”, “Motorized Antenna” and “Simple LNB”

Tuner 2 Connection type “Separated”/Tuner 2 Signal Configuration “Same with Tuner 1”:

All settings are made on tuner 1. The settings for the second tuner are automatically taken from the first tuner. Available settings for tuner 1 are: “DiSEqC™1.0”, “DiSEqC™1.1”, “Motorized Antenna” and “Simple LNB”

Tuner 2 Connection type “Separated”/Tuner 2 Signal Configuration “Different from Tuner 1”:

All settings must be made separately for the two tuners.

Available settings for tuner 1 are: “DiSEqC™1.0”, “DiSEqC™1.1”, “Motorized Antenna” and “Simple LNB”

Available settings for tuner 2 are (irrespective of the setting for tuner 1): “DiSEqC™1.0”, “DiSEqC™1.1”, “Motorized Antenna” and “Simple LNB”

Use the buttons to set the “Tuner 2 Connection type” and “Tuner 2 Signal Configuration” parameters to the appropriate setting for your reception system.

Continue as described in the first installation for the type of reception you have selected.

18

Page 18
Image 18
Kathrein UFS 922 si, UFS 922 sw manual Tuner 2 Connection type Loopthrough