Kathrein UFS 922 si, UFS 922 sw manual Satellite Configuration Tuner

Connection and setup

The following display appears:

Satellite Configuration - Tuner 1

Make the settings for the first satellite for tuner 1 here.

LNB Type:

If your reception system does not have a Universal LNB, use the buttons to select the LNB types that are used in your reception system. You can choose from the following LNB types:

-Universal

-Simple or

-User-defined

LNB frequency (MHz):

You only need to specify this data if your LNB type is not “Universal LNB”. The data required differ for the settings “Simple” and “User-defined”. Refer to the documentation supplied for your LNB.

-	Selection “Simple” LNB:		Use the numeric keypad to enter the LNB frequency
-	Selection “User-defined”:		Press the button to input the required low, high and limit frequencies as necessary.
			The input is performed using the numeric keypad
DiSEqC™ Input:
-	1 of 4:	For the first satellite on the tuner (item A on the system)

-2 of 4:For the second satellite on the tuner (item B on the system)

-3 of 4:For the third satellite on the tuner (item C on the system)

-4 of 4:For the fourth satellite on the tuner (item D on the system)

DiSEqC™ Repeat:

The setting for how often the DiSEqC™ command must be repeated depends on the configuration of your reception system. Refer to the documentation for your reception system or seek assistance from a specialist engineer.

-	Off	DiSEqC™ command is not repeated
-	1	DiSEqC™ command is repeated once
-	2	DiSEqC™ command is repeated twice or
-	3	DiSEqC™ command is repeated three times

20