Kathrein UFS 922 sw, UFS 922 si manual DiSEqC1.1

Connection and setup

22 kHz signal:

You only need to specify this data if your LNB type is “Simple”. The 22 kHz signal is needed to switch LNBs in multi-feed reception and to switch between Low and High band.

-On

-Off

Test-Transponder:

Select the “Test-Transponder” field. Here you can select a transponder for checking whether your settings are correct using the signal strength bar and signal quality bar.

When you have completed all settings for this satellite, press the (green) button.

If you have selected more than one satellite (max. four) for tuner 1, the receiver will automatically skip to the settings for the second satellite. Now make the settings for the second satellite, followed by the third and fourth satellites as required, in the same way as described for the first satellite.

Once all settings for all the satellites that you selected have been completed, the receiver will automatically skip to the settings for the second tuner (assuming that for the second tuner you selected the connection type “Separated” and set the signal configuration to “Different from Tuner 1”). If this is the case, now make the settings for the second tuner in the same way as you did for the first tuner.

Once you have completed the settings for both tuners and the satellites assigned to them, the receiver will automatically display the screen for the channel search. Continue the first installation with the “Channel search” chapter.

DiSEqC™1.1

The individual items are selected using the  buttons. If you require to access submenus, they can be called up using the button. Changes to the current settings can be made using the buttons or the numeric keypad.

Press the (green) button.

21