Switching Commands
100
ProSafe Managed Switch
dot1x re-authenticate
This command begins the re-authentication sequence on the specified port. This command is
only valid if the control mode for the specified port is “auto” or “mac-based”. If the control
mode is not “auto” or “mac-based”, an error will be returned.
Format dot1x re-authenticate <unit/slot/port>
Mode
dot1x re-authentication
This command enables re-authentication of the supplicant for the specified port.
Default
Format dot1x re-authentication
Mode
no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
Format no dot1x re-authentication
Mode
dot1x system-auth-control
Use this command to enable the dot1x authentication support on the switch. While disabled,
the dot1x configuration is retained and can be changed, but is not activated.
Default
Format dot1x system-auth-control
Mode
no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
Format no dot1x system-auth-control
Mode
Privileged EXEC
disabled
Interface Config
Interface Config
disabled
Global Config
Global Config