NETGEAR GSM7228PS-100NAS snmp-server enable traps multiusers, snmp-server enable traps stpmode, snmptrap

Management Commands
688
ProSafe Managed Switch
snmp-server enable traps multiusers
Use this command to enable Multiple User traps. When the traps are enabled, a Multiple
User Trap is sent when a user logs in to the terminal interface (EIA 232 or Telnet) and there is
an existing terminal interface session.
Default
Format snmp-server enable traps multiusers
Mode
no snmp-server enable traps multiusers
Use this command to disable Multiple User traps.
Format no snmp-server enable traps multiusers
Mode
snmp-server enable traps stpmode
Use this command to enable sending new root traps and topology change notification traps.
Default
Format snmp-server enable traps stpmode
Mode
no snmp-server enable traps stpmode
Use this command to disable sending new root traps and topology change notification traps.
Format no snmp-server enable traps stpmode
Mode
snmptrap
Use this command to add an SNMP trap receiver. The maximum length of <name> is 16
case-sensitive alphanumeric characters. The <snmpversion> is the version of SNMP. The
version parameter options are snmpv1 or snmpv2. The SNMP trap address can be set using
both an IPv4 address format as well as an IPv6 global address format.
The following shows an example of the CLI command.
(Netgear Switch)# snmptrap mytrap ip6addr 3099::2
enabled
Global Config
Global Config
enabled
Global Config
Global Config