Using the Command-Line Interface
15
ProSafe Managed Switch
Interface Config Switch (Interface <unit/slot/port>)#
Switch (Interface Loopback <id>)#
Switch (Interface Tunnel <id>)#
Manages the operation of an interface and
provides access to the router interface
configuration commands.
Use this mode to set up a physical port for a
specific logical connection operation.
Line Config Switch (line)# Contains commands to configure outbound
telnet settings and console interface settings.
Policy Map
Config Switch (Config-policy-map)# Contains the QoS Policy-Map configuration
commands.
Policy Class
Config Switch (Config-policy-class-map)# Consists of class creation, deletion, and
matching commands. The class match
commands specify Layer 2, Layer 3, and
general match criteria.
Class Map Config Switch (Config-class-map)# Contains the QoS class map configuration
commands for IPv4.
Ipv6_Class-Map
Config Switch (Config-class-map)# Contains the QoS class map configuration
commands for IPv6.
Router OSPF
Config Switch (Config-router)# Contains the OSPF configuration commands.
Router OSPFv3
Config Switch (Config rtr)# Contains the OSPFv3 configuration commands.
Router RIP Config Switch (Config-router)# Contains the RIP configuration commands.
MAC Access-list
Config Switch (Config-mac-access-list)# Allows you to create a MAC Access-List and to
enter the mode containing MAC Access-List
configuration commands.
TACACS Config Switch (Tacacs)# Contains commands to configure properties for
the TACACS servers.
DHCP Pool
Config Switch (Config dhcp-pool)# Contains the DHCP server IP address pool
configuration commands.
DHCPv6 Pool
Config Switch (Config dhcp6-pool)# Contains the DHCPv6 server IPv6 address pool
configuration commands.
Stack Global
Config Mode Switch (Config stack)# Allows you to access the Stack Global Config
Mode.
ARP Access-List
Config Mode Switch (Config-arp-access-list)# Contains commands to add ARP ACL rules in
an ARP Access List.
Table 5. CLI Command Modes (Continued)
Command Mode Prompt Mode Description