21
2
2. Stacking Commands
This chapter contains the following sections:
• Dedicated Port Stacking
• Stacking Commands
• Non-Stop Forwarding Commands
• Stack Firmware Synchronization Commands
The commands in this chapter are in two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
The Primary Management Unit is the unit that controls the stack.
Note: When configuring a stack using M5300 Series switches and
GSM7328S V2H1, GSM7352S V2H1, GSM7228PS V1H1, or
GSM7228PS V1H1switches, refer to sdm prefer (Mixed Stacking)
on page 715.
Dedicated Port Stacking
This section describes the commands you use to configure dedicated port stacking.

stack

This command sets the mode to Stack Global Config.

member

This command configures a switch. The <unit> is the switch identifier of the switch to be
added/removed from the stack. The <switchindex> is the index into the database of the
Format stack
Mode Global Config